Follow these steps in order to change your NetWare 4.x server's network protocol information to conform with the Gigabit migration of your building.
At the server's console, load inetcfg.nlm
Fig 1: inetcfg.nlm
Select Protocols
Fig 2: Protocols menu
Select TCP/IP
Fig 3: TCP/IP Protocols Menu
Ensure that:
Select LAN Static Routing Table: to view the list of static routes
Fig 3: LAN Static Routing Table
There should be one entry. If there is no entry, hit <INS> to create one.
Select the Default Route
Fig 4: Default Route
Ensure that the Next Hop Router on Route: is set with the gateway address you were assigned.
After you modify the address press <enter> to save the address, hit <ESC>, and save the changes. Hit <ESC> confirming saves until you are back at the first inetcfg menu.
Select Bindings
Fig 5: inetcfg bindings
Fig 6: Bindings Menu
Select TCP/IP
Fig 7: TCP/IP Bindings
Select and change the Subnetwork Mask of Connected Network: to match the network mask given to you.
Press <enter> to save the mask, hit <ESC>, and save the changes.
From the Bindings menu, select IPX. (If IPX is bound)
Fig 8: IPX Bindings
Select IPX Network Number:
Change it to match the new IPX network number you were assigned. Press <enter> to save the number, hit <ESC>, and save the changes.
IMPORTANT!
If you are ready to apply these changes to the server, reboot the server. However, if your building is not yet switched to the gigabit network, this will result in A LOSS OF SERVICE. Only apply these changes when your building is cut over to the gigabit network. If you are unsure about when to apply the changes, contact your DNL or the EITS Helpdesk (542-3106).
Any questions or concerns, please contact the EITS Helpdesk (542-3106) for assistance.
Back to NetWare Gigabit Migration Page
| Report
problems or suggestions to weaver@arches.uga.edu This page last updated Thursday, December 6, 2001 10:42 AM © 2001 Michael Weaver |
 |